Pusher Cutter Trailer

Pusher Cutter Trailer has been specifically designed to pull cable out of conduits or the ground during recovery for scrapping of the precious metals. The trailer mounted machine consists of a 20kN Cable Pusher, Cable Cutter and cable chutes to direct cable off-cuts into a tip truck or similar vehicle.  

The Cable Pusher Cutter Trailer must be attached to the towing vehicle when in operation. The two rear jacklegs must be deployed and the trailer levelled. The unit is controlled by a pendant attached to the kerb side of the trailer. The Cable Pusher Cutter Trailer will pull the cable from the manhole through the pusher and cut the cable into lengths or approximately 1 meter. The cable off-cuts will travel along the chute and into the towing vehicle (tip truck or similar).  

The Cable Pusher Cutter Trailer is fully self-contained with its own diesel power unit and all equipment needed to do the cable scrapping job.
Write your awesome label here.

What's included?

  • Recommended personal protective equipment (PPE)
  • Setup safety warnings and recommendations
  • Pre-start checks for trailer and cable pusher/cutter
  • Component identification
  • How to setup the pusher/cutter trailer
  • How to adjust the speed and cable side pressure
  • How to set the cable into the pusher/cutter and how to set different cable diameters
  • Learn the pusher/cutter power pack start-up procedure
  • Learn how to operate the pusher/cutter with the pendant control
  • Learn how to pull cable into the pusher/cutter using the capstan winch
  • Learn how to pack up the pusher/cutter trailer ready to tow to the next job site
Created with